The Flash VersaPort attachment for your printer is different from the regular VersaPort in that it has a power cord that must be plugged in and it is printer specific. It is not interchangeable with other printers. You were sent the version that is compatible with your specific printer.When installing or removing the Flash VersaPort your printer must be turned off.
If you are using the parallel port to communicate with your printer:
- Turn your printer OFF.
- Plug the VersaPort into the parallel port on your printer.
- Connect the cable from your computer directly to the VersaPort.
If you are not using the parallel port to communicate with your printer:
- Turn your printer OFF.
- Plug the VersaPort into the parallel port on your printer. The VersaPort will function properly with any method of connnection to the network or host computer.
When your printer is powering up, the VersaPort will configure your printer with the options programmed into your VersaPort.Reset/Reload Button Functions:
- Five presses of the button will print the Version and Configuration Settings.
- Four presses of the button will print the Test and Instruction Information.
- One press of the button will reset the VersaPort.
Auxiliary Power:
The auxiliary power jack is located on the opposite side of the black button. Most printers require auziliary power for normal operation.
[This message has been edited by Pamela (edited 11-21-2002).]
Navigator User Forums
UBBFriend: Email This Page to Someone! 
posted 11-21-2002 12:03 PM
